To begin with, HANSA is a Lithuanian manufacturer of means for cleaning solid fuel boilers, stoves and chimneys from soot and resins that appear in the process of using equipment that operates on solid fuels.

This manufacturer has proven itself in the Ukrainian market and is one of the most popular products in this segment. According to user feedback, if you regularly use these tools, the amount of plaque on the walls of the boiler and the chimney decreases and, therefore, it is necessary to simply pass from time to time a special brush on the walls of the furnace and the heat exchanger of the boiler and remove the residue of combustion products from the ash pan.

How does this tool work?

In the process of burning solid fuel, moisture is released, which, upon contact with soot (waste products of combustion), forms a dense coating on the internal walls of the boiler and chimney. This deposit is fireproof, but only accumulates. Directly in the chimney it there is a black sticky resin. All this leads to premature failure of the equipment, to a decrease in the productivity of its operation and can even cause a fire, accompanied by the appearance of a flame in the chimney.

The soot cleaner HANSA acts as a catalyst, binding moisture and destroying resin soot, which then simply falls away from the walls and then burns or falls into the ash pan.

We would like to draw your attention to the fact that this cleanser is still effective for some time after its first use. Moreover, it helps to burn fuel more efficiently.

How to use this tool?

For prevention, the manufacturer recommends using one measuring spoon of the agent for each kindling of the boiler, or for each complete laying of firewood or other solid fuel. The agent can fall asleep until the heat of the flame, or, dropping directly into the flame itself.

Attention!!! To sleep, the product must be so that it does not burn (if there is an open flame), do not touch it with bare hands, use protective gloves when working and so that the crystals do not wake up in the ash pan, because in this case there will be no cleaning effect. After using the product, we recommend that you wash your hands thoroughly.

If your equipment is heavily contaminated, we recommend increasing the dose 1.5-2 times for better effect. If necessary, repeat the procedure after one hour of operation of the boiler.

Recommendations on the frequency of application - the tool can be used for every fuel deposit in small quantities in preventive measures, or as the equipment is contaminated.